Please follow the steps below to setup your Sim Racing Studio LED Go Strip. If you already own a SRS Wind Kit or Tach, please skip steps 1, 5, 6 and 10.

1. Connect the Intellibox to your PC using the USB cable provided. 
2. Connect the Intellibox AUX port to LED Box using the Ethernet cable provided. 
3. Connect the LED Box to the Power Supply provided. 
4. Connect the Power Supply to a wall socket.
5. Download and install Sim Racing Studio from our download page here. 
6. Verify the Intellibox has a Green check mark in the HARDWARE STATUS box.
   1. If the Intellibox does not have a Green check mark, please follow the Intellibox not connected troubleshooting found here.
      
7. Next click SETUP at the top of Sim Racing Studio and select Hardware on the left. Scroll down to the LED section and set number of LEDs you want active.
   
8. IMPORTANT: Click Save in the upper right in the PROFILE IN USE box to save your changes in Sim Racing Studio.
9. Test your LED Go Strip by clicking on the button next to Led in the HARDWARE STATUS window on the right. The button will change from AUTO to ALWAYS ON and the LED Go Strip will light up. Click the button again to cycle through OFF and one more time back to AUTO.
10. You can configure your LED Go Strip in Sim Racing Studio by clicking on TUNING at the top and selecting LED on the left. You'll be able to configure the number of segments and what you would like each segment to use as indicators.
11. Mount the LED Go Strip on your TV, motion simulator, or sim racing rig.
12. Finally, click on GAMES at the top of Sim Racing Studio and select PC or Console on the left to verify your game is Ready to play. If the game isn't ready to play, follow the guidance here.
    

Your Sim Racing Studio LED Go Strip is now installed, configured, and ready to use. Have fun! 

Note: The maximum amount of LEDs that can be used with the LED Go Strip and Sim Racing Studio is 144. 

Hardware Setup Video

Software Setup Video