If you have a 7 color tach and a programmer (2 button accessory that came in the box), please follow instructions below:


Put "WIND/Intellibox" in ALWAYS ON MODE...(That will ensure the tach is awake during programming)

then


Disable the buzz

  1. Hold Up and Down (at the same time) for 2 seconds (you will hear a beep)
  2. push Up
  3. wait 5 secs for confirmation (beep)

Change number of cylinders

  1. Hold Up and Down (At the same time) for 2 seconds (you will hear a beep)
  2. Push Down until the nail is on the number 2
  3. wait 5 secs for confirmation (beep)

Disable Warning

  1. Hold Down for 2 seconds (you will hear a beep)
  2. Push Up unil the nail hits 11k
  3. wait 5 secs for confirmation (beep)

Change Color

  1. Press Up
  2. Press Up Again
  3. Press Down many times until get the color desired (Blue)
  4. wait 5 secs for confirmation (beep)

Change Brightness

  1. Press Down
  2. Press Down many times until get the brightness desired (Max)
  3. wait 5 secs for confirmation (beep)